os x 64-bit?
gwright at antiope.com
Wed Nov 10 20:09:05 EST 2010
On 11/10/10 10:44 AM, Antoine Latter wrote:
> On Wed, Nov 10, 2010 at 9:04 AM, Gregory Wright<gwright at antiope.com> wrote:
>> I built ghc 7.0.1-rc2 yesterday 64-bit on Snow Leopard. Much of the work
>> in getting ghc to build 64-bit was done by Barney Stratford; the MacPorts
>> ghc 6.10.4 has built successfully in 64 bit mode for a number of months.
>> Until just a few weeks ago 6.12.x and HEAD wouldn't build 64-bit because
>> of changes in ghci. These changes were in part to remove the limitation
>> that modules
>> loaded by ghci had to be located below the 2 GB address boundary.
>> they revealed code paths in ghc's Mach-O linker that were never tested. (See
>> bug #4318. Other bugs may be partial duplicates; the tickets probably need
>> to be examined to check which ones are distinct.)
>> The good news is that the linker patches were done just in time for 7.0.1.
>> You should be all set to try the release candidates on Snow Leopard 64-bit.
>> I built my 7.0.1-rc2 using a 64 bit 6.10.4. My original 64-bit 6.10.4 was
>> using a 32-bit 6.10.4 compiled on Leopard. Reports of trouble building the
>> 7.0.1 release candidates using a 32-bit bootstrap compiler would be
> Are there any instructions for building in this fashion from the
> source tarball or from VCS?
I used the tarball ghc-126.96.36.19901028.tar.bz2 and followed the
directions in the README file:
$ perl boot
(The "perl boot" command wasn't necessary, since I was building from a
of a darcs pull. However, it didn't cause any problems.)
I haven't run a testsuite on the build yet. Perhaps someone from
haskell HQ can
tell me which version of the tests I should run on 7.0.1-rc2?
More information about the Glasgow-haskell-users